NOTE:
Prior to checking the ignition timing, check the wiring connections of the entire ignition system.
Make sure all connections are tight and free of corrosion.
1. Remove:
2. Remove:
3. Lift the fuel tank. (Do not disconnect the fuel hose, fuel drain hose, and couplers.) Refer to "FUEL TANK" on page 7-1.
4. Connect:
5. Check:
a. Start the engine, warm it up for several minutes, and then let it run at the specified engine idling speed.
b. Check that stationary pointer "a" in the generator cover is within the firing range "b" on the generator rotor.
Incorrect firing range → Check the ignition system.
NOTE:
The ignition timing is not adjustable.
6. Remove:
7. Install:
8. Install:
9. Install:
Checking the spark plug
1. Remove:
Right side cover
Refer to "GENERAL CHASSIS" on page 4-1.
2. Disconnect:
Spark plug cap
3. Remove:
Spark plug
CAUTION:Before removing the spark plug, blow away
any dirt accumulated in the spark plug well
with compressed air to prevent it from falling
...
Cast wheels
To maximize the performance, durability,
and safe operation of your vehicle,
note the following points regarding the
specified wheels.
The wheel rims should be checked
for cracks, bends or warpage before
each ride. If any damage is
found, have a Yamaha dealer replace
the wheel. ...
Cleaning and lubricating the drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrication
chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
The drive chain must be lubricated
...