1. Check:
WARNING Do not attempt to straighten a bent handlebar as this may dangerously weaken it. |
Installing the starter clutch
1. Install:
Starter clutch assembly
Starter clutch bolts "1"
NOTE:
While holding the generator rotor "2" with the
sheave holder "3", tighten the starter clutch
bolts.
Do not allow the sheave holder to touch the
projection on the generator rotor.
Stake the end "a" of each start ...
Checking the shift forks
The following procedure applies to all of the shift
forks.
1. Check:
Shift fork cam follower "1"
Shift fork pawl "2"
Bends/damage/scoring/wear
Replace the
shift fork.
2. Check:
Shift fork guide bar
Roll the shift fork guide bar on a flat surface.
Bends Replace. ...
Lubricating the drive chain
The drive chain consists of many interacting
parts. If the drive chain is not maintained properly,
it will wear out quickly. Therefore, the drive
chain should be serviced, especially when the
vehicle is used in dusty areas.
This vehicle has a drive chain with small rubber
O-rings between eac ...