1. Drain the fuel from the fuel tank.
2. Check:
Fuel sender resistance Out of specification → Replace the fuel sender.
a. Connect the pocket tester ( ×
10) to the fuel
sender coupler as shown.
A. Full fuel tank position
B. Empty fuel tank position
b. Measure the fuel sender resistance.
Checking the clutch plates
The following procedure applies to all of the
clutch plates.
1. Check:
Clutch plate
Damage Replace the clutch
plates as a
set.
2. Measure:
Clutch plate warpage
(with a surface plate and thickness gauge "1")
Out of specification Replace
the clutch
plates as a set.
...
Checking the rear wheel
1. Check:
Rear wheel axle
Rear wheel
Wheel bearings
Oil seals
Refer to "CHECKING THE FRONT WHEEL"
on page 4-8.
2. Check:
Tire
Rear wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-23 and "CHECKING THE WHEELS" on
page 3-25.
3. Measure:
Radi ...
Separating the crankcase
1. Remove:
Crankcase bolts
NOTE:
Loosen each bolt 1/4 of a turn at a time, in stages
and in the proper sequence as shown.
A. Right crankcase
B. Left crankcase
2. Turn:
Shift drum segment
NOTE:
Turn the shift drum segment "1" to the position
shown in the illustration. In this ...