1. Check:
a. Remove the fuel hose connector cover "1" and disconnect the fuel hose "2" from the fuel pump.
CAUTION: Although the fuel has been removed from the fuel tank, be careful when removing the fuel hose, since there may be fuel remaining in it. |
NOTE:
Before removing the hose, place a few rags in the area under where it will be removed.
b. Connect the pressure gauge "3" and fuel pressure adapter "4".
c. Start the engine.
d. Measure the fuel pressure.
Faulty Replace the fuel tank (with fuel pump).
e. Connect the fuel hose and install the fuel hose connector cover.
Refer to "INSTALLING THE FUEL HOSE" on page 7-2.
Checking the radiator fan motor
1. Check:
Radiator fan motor
Faulty/rough movement → Replace.
a. Disconnect the radiator fan motor coupler
from the wire harness.
b. Connect the battery (DC 12 V) as shown.
Positive tester probe →
blue "1"
Negative tester probe →
black "2"
c. Measure ...
Installing the shift forks and shift drum assembly
1. Install:
Shift fork-L "1"
Shift fork-C "2"
Shift fork-R "3"
Shift drum assembly "4"
Springs
Shift fork guide bar "5"
NOTE:
The embossed marks on the shift forks should
face towards the right side of the engine and be
in the following sequence: "R", "C", "L".
2. Check:
Tr ...
Cleaning and lubricating the drive chain
The drive chain must be cleaned and
lubricated at the intervals specified in
the periodic maintenance and lubrication
chart, otherwise it will quickly wear
out, especially when riding in dusty or
wet areas. Service the drive chain as
follows.
NOTICE
The drive chain must be lubricated
...