The following procedure applies to both of the front fork legs.
1. Check:
WARNING Do not attempt to straighten a bent inner tube as this may dangerously weaken it. |
2. Measure:
3. Check:
Obstruction Blow out all
of the oil passages
with compressed air.
CAUTION: When disassembling and assembling the front fork leg, do not allow any foreign material to enter the front fork. |
Removing the primary drive gear and balancer gears
1. Loosen:
Primary drive gear nut "1"
NOTE:
Place the aluminum plate "a" between the balancer
drive gear "2" and the balancer driven
gear "3", and then loosen the primary drive gear
nut.
2. Straighten the lock washer tab.
3. Loosen:
Balancer driven gear nut "1"
NOTE:
Place ...
Checking and lubricating the cables
The operation of all control cables and
the condition of the cables should be
checked before each ride, and the cables
and cable ends should be lubricated
if necessary. If a cable is damaged
or does not move smoothly, have a
Yamaha dealer check or replace it.
WARNING! Damage to the out ...
VInstalling the handlebars
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Install:
Front brake master cylinder "1"
Front brake master cylinder holder "2"
Front brake light switch
NOTE:
Install the brake master cyl ...