1. Remove:
2. Check:
3. Measure:
a. Place the vehicle on a suitable stand so that the front wheel is elevated.
b. Before measuring the front brake disc deflection, turn the handlebar to the left or right to ensure that the front wheel is stationary.
c. Remove the brake caliper.
d. Hold the dial gauge at a right angle against the brake disc surface.
e. Measure the deflection 1.5 mm (0.06 in) below the edge of the brake disc.
4. Measure:
Out of specification Replace.
5. Adjust:
a. Remove the brake disc.
b. Rotate the brake disc by one bolt hole.
c. Install the brake disc.
NOTE:
Tighten the brake disc bolts in stages and in a crisscross pattern.
d. Measure the brake disc deflection.
e. If out of specification, repeat the adjustment steps until the brake disc deflection is within specification.
f. If the brake disc deflection cannot be brought within specification, replace the brake disc.
6. Install:
Checking the engine oil level
1. Stand the vehicle on a level surface.
NOTE:
Place the vehicle on a suitable stand.
Make sure the vehicle is upright.
2. Start the engine, warm it up for several minutes,
and then turn it off.
3. Check:
Engine oil level
The engine oil level should be between the
minimum level ...
Checking the rocker arms and rocker arm shafts
The following procedure applies to all of the
rocker arms and rocker arm shafts.
1. Check:
Rocker arm
Damage/wear Replace.
2. Check:
Rocker arm shaft
Blue discoloration/excessive wear/pitting/
scratches Replace or
check the lubrication
system.
3. Measure:
Rocke ...
Checking the spark plug cap
1. Check:
Spark plug cap resistance
Out of specification Replace.
a. Remove the spark plug cap from the spark
plug lead.
b. Connect the pocket tester ( × 1k)
to the
spark plug cap as shown.
c. Measure the spark plug cap resistance. ...