Yamaha YZF-R125 Service Manual: Checking the friction plates
The following procedure applies to all of the friction plates.
1. Check:
- Friction plate
Damage/wear
Replace the
friction plates as a set.
2. Measure:
- Friction plate thickness
Out of specification
Replace
the friction plates as a set.
NOTE:
Measure the friction plate at four places.
A. Friction plate 1
B. Friction plate 2
C. Friction plate 3 (Green)
a. Green paint
Removing the clutch
1. Straighten the lock washer tab.
2. Loosen:
Clutch boss nut "1"
NOTE:
While holding the clutch boss "2" with the universal
clutch holder "3", loosen the clutch boss nut.
...
Checking the clutch plates
The following procedure applies to all of the
clutch plates.
1. Check:
Clutch plate
Damage Replace the clutch
plates as a
set.
2. Measure:
Clutch plate warpage
(with a surface p ...
Other materials:
Checking the thermostat
1. Check:
Thermostat
Does not open at 80.5-83.5 C (176.9-182.3
F) Replace.
a. Suspend the thermostat "1" in a container "2"
filled with water.
b. Slowly heat the water "3".
c. Place a thermometer "4" in the water.
d. While stirring the water, observe the thermostat
and th ...
Rider seat
To remove the rider seat
Insert the key into the seat lock,
and then turn it clockwise.
Seat lock
Open.
Pull the rider seat off.
To install the rider seat
1. Insert the projection on the front of
the rider seat into the seat holder
as shown.
Projection
...
Checking the fuel pressure
1. Check:
Pressure regulator operation
a. Remove the fuel hose connector cover "1"
and disconnect the fuel hose "2" from the fuel
pump.
CAUTION:Although the fuel has been removed from
the fuel tank, be careful when removing the
fuel hose, since there may be fuel remaining
i ...