1. Disconnect:
2. Check:
a. Disconnect the FID (fast idle solenoid) coupler from the FID.
b. Connect the pocket tester ( × 10)
to the terminals
of the FID (fast idle solenoid).
c. Measure the FID (fast idle solenoid) resistance.
Out of specification Replace
the throttle
body assembly.
Removing the handlebars
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Remove:
Handlebar grip "1"
NOTE:
Blow compressed air between the handlebar
and the handlebar grip, and gradually push the
grip off the handleb ...
Removing the throttle body
1. Extract the fuel in the fuel tank through the
fuel tank filler hole with a pump.
2. Disconnect:
Fuel hose
WARNINGCover the fuel hose connections with a
cloth
when disconnecting them. Residual pressure
in the fuel lines could cause fuel to
spurt out when removing the h ...
Checking the coolant level
1. Stand the vehicle on a level surface.
NOTE:
Place the vehicle on a suitable stand.
Make sure the vehicle is upright.
2. Check:
Coolant level
The coolant level should be between the
maximum level mark "a" and minimum level
mark "b".
Below the minimum level mark → Add t ...