Yamaha YZF-R125 Service Manual: Checking the exhaust system
1. Check:
- Exhaust assembly "1" Cracks/damage → Replace.
- Exhaust pipe gasket "2" Exhaust gas leaks → Replace.
2. Check:
- Tightening torques of the exhaust pipe nuts
"3" and exhaust assembly bolts "4"
Checking the cylinder head breather hose
1. Remove:
Left side panel
Refer to "GENERAL CHASSIS" on page 4-1.
2. Check:
Cylinder head breather hose "1"
Cracks/damage → Replace.
Loose connection → Connect properly ...
Checking the coolant level
1. Stand the vehicle on a level surface.
NOTE:
Place the vehicle on a suitable stand.
Make sure the vehicle is upright.
2. Check:
Coolant level
The coolant level should be between the
max ...
Other materials:
Removing the front fork legs
The following procedure applies to both of the
front fork legs.
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Loosen:
Handlebar pinch bolt "1"
Handlebar bolt "2"
Upper bracket ...
Checking the crankshaft position sensor
1. Disconnect:
Crankshaft position sensor coupler
(from the wire harness)
2. Check:
Crankshaft position sensor resistance
Out of specification Replace
the crankshaft
position sensor/stator assembly.
a. Connect the pocket tester ( × 100) to the
crankshaft position sensor c ...
Troubleshooting details
This section describes the measures per fault code number displayed on the FI
diagnostic tool. Check
and service the items or components that are the probable cause of the
malfunction following the order
given.
After the check and service of the malfunctioning part have been completed,
re ...