Yamaha YZF-R125 Service Manual: Checking the engine oil level

1. Stand the vehicle on a level surface.

NOTE:

  • Place the vehicle on a suitable stand.
  • Make sure the vehicle is upright.

2. Start the engine, warm it up for several minutes, and then turn it off.

3. Check:

  • Engine oil level

The engine oil level should be between the minimum level mark "a" and maximum level mark "b".

Below the minimum level mark → Add the recommended engine oil to the proper level.

NOTE:

  • Before checking the engine oil level, wait a few minutes until the oil has settled.
  • Do not screw the engine oil filler cap (dipstick) "1" in when checking the oil level.

Checking the engine oil level



CAUTION:
  • Engine oil also lubricates the clutch and the wrong oil types or additives could cause clutch slippage. Therefore, do not add any chemical additives or use engine oils with a grade of "CD" "c" or higher and do not use oils labeled "ENERGY CONSERVING II" "d".
  • Do not allow foreign materials to enter the crankcase.

4. Start the engine, warm it up for several minutes, and then turn it off.

5. Check the engine oil level again.

NOTE:

Before checking the engine oil level, wait a few minutes until the oil has settled.

    Measuring the compression pressure
    NOTE: Insufficient compression pressure will result in a loss of performance. 1. Measure: Valve clearance Out of specification →Adjust. Refer to "ADJUSTING THE VALVE CLEARANCE" on page ...

    Changing the engine oil
    1. Remove: Right bottom cowling Right upper side cowling Right lower side cowling Refer to "GENERAL CHASSIS" on page 4-1. 2. Start the engine, warm it up for several minutes, and then tu ...

    Other materials:

    Checking the front and rear brake pads
    The front and rear brake pads must be checked for wear at the intervals specified in the periodic maintenance and lubrication chart. Front brake pads Remove the front brake caliper by removing the bolts. Bolt Brake caliper Lining thickness Check each front br ...

    Specifications
    Dimensions: Overall length: 2015 mm (79.3 in) Overall width: 660 mm (26.0 in) Overall height: 1065 mm (41.9 in) Seat height: 818 mm (32.2 in) Wheelbase: 1355 mm (53.3 in) Ground clearance: 155 mm (6.10 in) Minimum turning radius: 3100 mm (122.0 in) Weight: With oil and fuel: 138.0 k ...

    Checking the clutch boss
    1. Check: Clutch boss splines Damage/pitting/wear Replace the clutch boss. NOTE: Pitting on the clutch boss splines will cause erratic clutch operation. Checking the pressure plate 1. Check: Pressure plate Cracks/damage Replace. Checking the clutch push lever and short clutch push ...

    2024 Copyright www.yam-r125.net |