Yamaha YZF-R125 Service Manual: Checking the drive sprocket

Yamaha YZF-R125 Service Manual / Chassis / Chain drive / Checking the drive sprocket

1. Check:

  • Drive sprocket More than 1/4 tooth "a" wear
    Replace the drive chain sprockets as a set.

    Bent teeth Replace the drive
    chain sprockets as a set.

Checking the drive sprocket


b. Correct

1. Drive chain roller

2. Drive chain sprocket

Checking the rear wheel sprocket

Refer to "CHECKING AND REPLACING THE REAR WHEEL SPROCKET" on page 4-15.

Checking the rear wheel drive hub

Refer to "CHECKING THE REAR WHEEL DRIVE HUB" on page 4-15.

    Checking the drive chain
    1. Measure: 15-link section "a" of the drive chain Out of specification Replace the drive chain. a. Measure the length "a" between the inner sides of the pins and the length "b" between t ...

    Installing the drive chain
    1. Lubricate: Drive chain Master link 2. Install: Drive sprocket Drive sprocket retainer bolts 3. Install: Master link O-rings Master link plate Master link clip "1" ...

    Other materials:

    Checking the decompression system
    1. Check: Decompression system a. Check the decompression system with the camshaft sprocket and the decompression cam installed to the camshaft. b. Check that the decompression lever "1" moves smoothly. c. Without operating the decompression lever, check that the decompression cam " ...

    Adjusting the rear disc brake
    1. Check: Brake pedal position (distance "a" from the center of the rider footrest to the center of the brake pedal) Out of specification Adjust. 2. Adjust: Brake pedal position a. Loosen the locknut "1". b. Remove the cotter pin "2", washer "3", and pin "4". c. Turn t ...

    Removing the generator
    1. Remove: Generator rotor nut "1" Washer NOTE: While holding the generator rotor "2" with the sheave holder "3", loosen the generator rotor nut. Do not allow the sheave holder to touch the projection on the generator rotor. 2. Remove: Generator rotor "1" (with the ...

    2024 Copyright www.yam-r125.net |