1. Measure:
a. Measure the length "a" between the inner sides of the pins and the length "b" between the outer sides of the pins on a 15-link section of the drive chain as shown in the illustration.
b. Calculate the length "c" of the 15-link section of the drive chain using the following formula.
Drive chain 15-link section length "c" = (length "a" between pin inner sides + length "b" between pin outer sides)/2
NOTE:
2. Clean:
a. Wipe the drive chain with a clean cloth.
b. Put the drive chain in kerosene and remove any remaining dirt.
c. Remove the drive chain from the kerosene and completely dry it.
CAUTION:
|
3. Check:
Cracks Replace the drive
chain.
4. Lubricate:
For your safety - pre-operation checks
Inspect your vehicle each time you use it to make sure the vehicle is in safe
operating condition. Always follow the inspection
and maintenance procedures and schedules described in the Owner's Manual.
WARNING
Failure to inspect or maintain the vehicle properly increases the possibility of
...
Storage
Short-term
Always store your motorcycle in a cool,
dry place and, if necessary, protect it
against dust with a porous cover.
NOTICE
Storing the motorcycle in a
poorly ventilated room or covering
it with a tarp, while it is still
wet, will allow water and humidity
to seep in and ...
Installing the radiator
1. Fill:
Cooling system
(with the specified amount of the recommended
coolant)
Refer to "CHANGING THE COOLANT" on
page 3-15.
2. Check:
Cooling system
Leaks Repair or replace any
faulty part.
3. Measure:
Radiator cap opening pressure
Below the specified pressure Repla ...