1. Check:
2. Measure:
a. Measure cylinder bore "C" with the cylinder bore gauge.
NOTE:
Measure cylinder bore "C" by taking side-to-side and front-to-back measurements of the cylinder.
Then, find the average of the measurements.
b. If out of specification, replace the cylinder, and replace the piston and piston rings as a set.
c. Measure piston skirt diameter D "a" with the micrometer.
b. 5.0 mm (0.20 in) from the bottom edge of the piston
d. If out of specification, replace the piston and piston rings as a set.
e. Calculate the piston-to-cylinder clearance with the following formula.
f. If out of specification, replace the cylinder, and replace the piston and piston rings as a set.
Installing the relay arm
1. Lubricate:
Spacers
Bearings
Oil seals
Bolts (unthreaded shaft portion only)
2. Install:
Bearing "1"
(to the relay arm)
Oil seal "2"
(to the relay arm)
3. Rear shock absorber assembly
4. Relay arm
5. Connecting arm
A. Left side
B. Right side ...
Removing the rear wheel (disc)
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle
so that there is
no danger of it falling over.
2. Elevate:
Rear wheel
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated.
3. Remove:
Rear brake caliper
NOTE: ...
Checking the switches
1. Clutch switch
2. Main switch
3. Front brake light switch
4. Sidestand switch
5. Rear brake light switch
6. Neutral switch
7. Turn signal switch
8. Horn switch
9. Dimmer switch
10.Pass switch
11.Engine stop switch
12.Start switch
Check each switch for continuity with the pocket tes ...