Yamaha YZF-R125 Service Manual: Checking the crankshaft
1. Measure:
- Crankshaft runout
Out of specification
Replace
the crankshaft, bearing or both.
NOTE:
Turn the crankshaft slowly.
2. Measure:
- Big end side clearance
Out of specification
Replace
the crankshaft.
3. Measure:
- Crankshaft width
Out of specification
Replace the crankshaft.
3. Measure:
- Crankshaft width
Out of specification Replace the crankshaft.
4. Check:
- Crankshaft sprocket
Damage/wear
Replace the
crankshaft. - Bearing
Cracks/damage/wear
Replace the
crankshaft.
5. Check:
- Crankshaft journal
Scratches/wear
Replace the
crankshaft. - Crankshaft journal oil passage
Obstruction
Blow out with
compressed air.
Removing the crankshaft
1. Remove:
Crankshaft "1"
NOTE:
Remove the crankshaft with the crankcase
separating tool "2".
Make sure the crankcase separating tool is
centered over the crankshaft.
CAUTIO ...
Installing the crankshaft
1. Install:
Crankshaft "1"
NOTE:
Install the crankshaft with the crankshaft installer
pot "2", crankshaft installer bolt "3", adapter
(M12) "4" and spacer (crankshaft installer) "5".
...
Other materials:
Checking the crankshaft position sensor
1. Disconnect:
Crankshaft position sensor coupler
(from the wire harness)
2. Check:
Crankshaft position sensor resistance
Out of specification Replace
the crankshaft
position sensor/stator assembly.
a. Connect the pocket tester ( × 100) to the
crankshaft position sensor c ...
Adjusting the brake pedal free play
Adjusting the brake pedal free play
Brake pedal free play
The brake pedal free play should measure
3.5-4.5 mm (0.14-0.18 in) as
shown. Periodically check the brake
pedal free play and, if necessary, have
a Yamaha dealer adjust it.
WARNING
An incorrect brake pedal free play
in ...
Introduction
WARNINGDisc brake components rarely require
disassembly.
Therefore, always follow these preventive
measures:
Never disassemble brake components unless
absolutely necessary.
If any connection on the hydraulic brake
system is disconnected, the entire brake
sy ...