Check the leads, couplers, and connectors for stains, rust, moisture, etc.
1. Disconnect:
2. Check:
Moisture → Dry with an air blower.
Rust/stains → Connect and disconnect several times.
3. Check:
Loose connection → Connect properly.
NOTE:
If the pin "1" on the terminal is flattened, bend it up.
4. Connect:
NOTE:
Make sure all connections are tight.
5. Check:
NOTE:
If there is no continuity, clean the terminals.
When checking the wire harness, perform steps (1) to (3).
As a quick remedy, use a contact revitalizer available at most part stores.
Checking the front and rear brake pads
The front and rear brake pads must be
checked for wear at the intervals specified
in the periodic maintenance and
lubrication chart.
Front brake pads
Remove the front brake caliper by
removing the bolts.
Bolt
Brake caliper
Lining thickness
Check each front br ...
Installing the front brake master cylinder
1. Install:
Brake master cylinder "1"
Brake master cylinder holder "2"
NOTE:
Install the brake master cylinder holder with the
arrow mark "a" pointing forward.
Align the end of the brake master cylinder holder
with the punch mark "b" on the handlebar.
First, tighten the front bo ...
Engine oil and oil filter element
The engine oil level should be checked
before each ride. In addition, the oil
must be changed and the oil filter element
replaced at the intervals specified
in the periodic maintenance and lubrication
chart.
To check the engine oil level
Place the vehicle on a level surface
and hol ...