Yamaha YZF-R125 Service Manual: Checking the connecting arms and relay arm
1. Check:
- Connecting arms
- Relay arm
Damage/wear
Replace.
2. Check:
- Bearings
- Oil seals
Damage/pitting Replace.
3. Check:
Spacers
Damage/scratches Replace.
Checking the rear shock absorber assembly
1. Check:
Rear shock absorber rod
Bends/damage Replace the rear
shock
absorber assembly.
Rear shock absorber
Oil leaks Replace the rear
shock absorber
assembly.
Spring
Damage ...
Installing the relay arm
1. Lubricate:
Spacers
Bearings
Oil seals
Bolts (unthreaded shaft portion only)
2. Install:
Bearing "1"
(to the relay arm)
Oil seal "2"
(to the relay arm)
3. Rear shoc ...
Other materials:
Ignition circuit cut-off system
The ignition circuit cut-off system (comprising
the sidestand switch, clutch
switch and neutral switch) has the following
functions.
It prevents starting when the transmission
is in gear and the sidestand
is up, but the clutch lever is
not pulled.
It prevents starting when the t ...
Checking the steering
Worn or loose steering bearings may
cause danger. Therefore, the operation
of the steering must be checked as follows
at the intervals specified in the periodic
maintenance and lubrication
chart.
Place a stand under the engine to
raise the front wheel off the
ground. WARNING! To ...
Installing the radiator
1. Fill:
Cooling system
(with the specified amount of the recommended
coolant)
Refer to "CHANGING THE COOLANT" on
page 3-15.
2. Check:
Cooling system
Leaks Repair or replace any
faulty part.
3. Measure:
Radiator cap opening pressure
Below the specified pressure Repla ...