The following procedure applies to all of the bulbs.
1. Remove:
WARNING Since the headlight bulbs get extremely hot, keep flammable products and your hands away from them until they have cooled down. |
CAUTION:
|
2. Check:
NOTE:
Before checking for continuity, set the pocket tester to "0" and to the " × 1" range.
a. Connect the positive tester probe to terminal "1" and the negative tester probe to terminal "2", and check the continuity.
b. Connect the positive tester probe to terminal "1" and the negative tester probe to terminal "3", and check the continuity.
c. If either of the readings indicate no continuity, replace the bulb.
Chain drive
Removing the drive chain
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
NOTE:
Place the vehicle on a suitable stand so that the
rear wheel is elevated. ...
Installing the relay arm
1. Lubricate:
Spacers
Bearings
Oil seals
Bolts (unthreaded shaft portion only)
2. Install:
Bearing "1"
(to the relay arm)
Oil seal "2"
(to the relay arm)
3. Rear shock absorber assembly
4. Relay arm
5. Connecting arm
A. Left side
B. Right side ...
Identification
Vehicle identification number
The vehicle identification number "1" is stamped
into the right side of the steering head pipe.
Model label
The model label "1" is affixed to the frame. This
information will be needed to order spare parts.
...