The following procedure applies to all of the bulb sockets.
1. Check:
Bulb socket (for continuity) (with the pocket tester) No continuity Replace.
NOTE:
Check each bulb socket for continuity in the same manner as described in the bulb section, however, note the following.
a. Install a good bulb into the bulb socket.
b. Connect the pocket tester probes to the respective leads of the bulb socket.
c. Check the bulb socket for continuity. If any of the readings indicate no continuity, replace the bulb socket.
Troubleshooting
Any of the following fail to light: turn signal lights, brake light or
indicator lights.
The horn fails to sound.
The fuel gauge fails to operate.
The speedometer fails to operate.
NOTE:
Before troubleshooting, remove the following part(s):
1. Seats
2. Fuel tank
3. Left upper ...
Removing the generator
1. Remove:
Generator rotor nut "1"
Washer
NOTE:
While holding the generator rotor "2" with the
sheave holder "3", loosen the generator rotor
nut.
Do not allow the sheave holder to touch the
projection on the generator rotor.
2. Remove:
Generator rotor "1"
(with the ...
Adjusting the clutch lever free play
Adjusting the clutch lever free play
Clutch lever free play adjusting bolt
Clutch lever free play
The clutch lever free play should measure
10.0-15.0 mm (0.39-0.59 in) as
shown. Periodically check the clutch lever
free play and, if necessary, adjust it
as follows.
Slide the ...