Yamaha YZF-R125 Service Manual: Checking the clutch push rods

Yamaha YZF-R125 Service Manual / Engine / Transmission / Checking the clutch push rods

1. Check:

  • Long clutch push rod Cracks/damage/wear Replace the
    long clutch push rod.

2. Measure:

  • Push rod bending limit Out of specification Replace
    the long clutch push rod.

    Checking the transmission
    1. Measure: Main axle runout (with a centering device and dial gauge "1") Out of specification Replace the main axle. 2. Measure: Drive axle runout (with a centering device an ...

    Assembling the main axle and drive axle
    1. Install: Toothed washer "1" Circlip "2" NOTE: Be sure to install the circlip so that its sharp edge "a" is facing away from the toothed washer and gear. Be sure the circlip ends ...

    Other materials:

    Removing the crankshaft
    1. Remove: Crankshaft "1" NOTE: Remove the crankshaft with the crankcase separating tool "2". Make sure the crankcase separating tool is centered over the crankshaft. CAUTION: To protect the end of the crankshaft, place an appropriate sized socket between the c ...

    Catalytic converters
    This vehicle is equipped with catalytic converters in the exhaust system. WARNING The exhaust system is hot after operation. To prevent a fire hazard or burns: Do not park the vehicle near possible fire hazards such as grass or other materials that easily burn. Park the vehic ...

    Cleaning and lubricating the drive chain
    The drive chain must be cleaned and lubricated at the intervals specified in the periodic maintenance and lubrication chart, otherwise it will quickly wear out, especially when riding in dusty or wet areas. Service the drive chain as follows. NOTICE The drive chain must be lubricated ...

    2024 Copyright www.yam-r125.net |