Yamaha YZF-R125 Service Manual: Checking the clutch housing

Yamaha YZF-R125 Service Manual / Engine / Clutch / Checking the clutch housing

1. Check:

  • Clutch housing dogs "1" Damage/pitting/wear 
    Deburr the clutch housing dogs or replace the clutch housing.

NOTE:

Pitting on the clutch housing dogs will cause erratic clutch operation.

Checking the clutch housing


2. Check:

  • Bearing Damage/wear Replace the
    bearing and clutch housing.
    Checking the clutch springs
    The following procedure applies to all of the clutch springs. 1. Check: Clutch spring Damage Replace the clutch springs as a set. 2. Measure: Clutch spring free length "a" Out o ...

    Checking the clutch boss
    1. Check: Clutch boss splines Damage/pitting/wear Replace the clutch boss. NOTE: Pitting on the clutch boss splines will cause erratic clutch operation. Checking the pressure plate 1. C ...

    Other materials:

    Installing the rear brake master cylinder
    1. Install: Copper washers "1" Brake hose "2" Rear brake light switch "3" WARNINGProper brake hose routing is essential to insure safe vehicle operation. Refer to "CABLE ROUTING" on page 2-33. CAUTION:When installing the brake hose onto the brake master ...

    Removing the rear wheel (disc)
    1. Stand the vehicle on a level surface. WARNINGSecurely support the vehicle so that there is no danger of it falling over. 2. Elevate: Rear wheel NOTE: Place the vehicle on a suitable stand so that the rear wheel is elevated. 3. Remove: Rear brake caliper NOTE: ...

    Checking the bulbs and bulb sockets
    NOTE: Do not check any of the lights that use LEDs. Check each bulb and bulb socket for damage or wear, proper connections, and also for continuity between the terminals. Damage/wear  Repair or replace the bulb, bulb socket or both. Improperly connected Properly connect. No c ...

    2024 Copyright www.yam-r125.net |