Yamaha YZF-R125 Service Manual: Checking the bulbs and bulb sockets
NOTE:
Do not check any of the lights that use LEDs.
Check each bulb and bulb socket for damage or wear, proper connections, and also for continuity between the terminals.
Damage/wear
Repair or replace
the bulb,
bulb socket or both.
Improperly connected 
Properly
connect.
No continuity 
Repair or replace the
bulb, bulb
socket or both.
Checking the switches
1. Clutch switch
2. Main switch
3. Front brake light switch
4. Sidestand switch
5. Rear brake light switch
6. Neutral switch
7. Turn signal switch
8. Horn switch
9. Dimmer switch
10.Pass ...
Types of bulbs
The bulbs used on this vehicle are shown in the
illustration.
Bulbs "a" and "b" are used for the headlights
and usually use a bulb holder that must be detached
before removing the bulb. The m ...
Other materials:
Owner's tool kit
Owner's tool kit
Owner's tool kit
Engine oil drain attachment
The owner's tool kit is located under the
rider seat.
The service information included in this
manual and the tools provided in the
owner's tool kit are intended to assist
you in the performance of preventive
maint ...
Removing the front fork legs
The following procedure applies to both of the
front fork legs.
1. Stand the vehicle on a level surface.
WARNINGSecurely support the vehicle so that there
is
no danger of it falling over.
2. Loosen:
Handlebar pinch bolt "1"
Handlebar bolt "2"
Upper bracket ...
Checking the front wheel
1. Check:
Front wheel axle
Roll the wheel axle on a flat surface.
Bends → Replace.
WARNINGDo not attempt to straighten a bent wheel
axle.
2. Check:
Tire
Front wheel
Damage/wear → Replace.
Refer to "CHECKING THE TIRES" on page
3-23 and "CHECKING TH ...