1. Check:
Clean and lubricate the bearings, and then rotate the inner race with your finger.
Rough movement Replace.
Damage/wear Replace.
Special tools
The following special tools are necessary for complete and accurate tune-up
and assembly. Use only
the appropriate special tools as this will help prevent damage caused by the use
of inappropriate tools
or improvised techniques. Special tools, part numbers or both may differ
depending on the ...
Checking the primary drive gear
1. Remove:
Primary drive gear
Refer to "BALANCER GEAR" on page 5-53.
2. Check:
Primary drive gear
Damage/wear Replace the
primary drive
gear and clutch housing as a set.
Excessive noise during operation
Replace
the primary drive gear and clutch housing as
a set
...
Checking the ignition timing
NOTE:
Prior to checking the ignition timing, check the
wiring connections of the entire ignition system.
Make sure all connections are tight and free of
corrosion.
1. Remove:
Rider seat
Left lower side cowling
Refer to "GENERAL CHASSIS" on page 4-1.
2. Remove:
Timing mark acces ...