The operation of all control cables and the condition of the cables should be checked before each ride, and the cables and cable ends should be lubricated if necessary. If a cable is damaged or does not move smoothly, have a Yamaha dealer check or replace it.
WARNING! Damage to the outer
sheath may interfere with proper cable
operation and will cause the inner
cable to rust. Replace a
damaged cable as soon as possible
to prevent unsafe conditions.
Recommended lubricant: Engine oil |
Multi-function display
Multi-function display
Multi-function display
"RESET/SELECT" button
WARNING
Be sure to stop the vehicle before
making any setting changes to the
multi-function display. Changing
settings while riding can distract the
operator and increase the risk of an
accident.
The multi- ...
Assembling the water pump
1. Install:
Water pump seal "1"
(into the water pump housing "2")
CAUTION:Never lubricate the water pump seal
surface
with oil or grease.
NOTE:
Install the water pump seal with the special
tools.
Install the water pump seal with the special
tools to the specifi ...
Checking the speed sensor
1. Check:
Speed sensor output voltage
Out of specification → Replace.
a. Connect the pocket tester (DC 20 V) to the
speed sensor coupler (wire harness end) as
shown.
Positive tester probe
gray "1"
Negative tester probe
gray/black "2"
b. Set the main switch to "ON".
c. ...