Yamaha YZF-R125 Service Manual: Chassis tightening torques
NOTE:
- First, tighten the lower ring nut to approximately 48 Nm (4.8 m.kg, 35 ft.lb) with a torque wrench, then loosen the lower ring nut completely.
- Retighten the lower ring nut to 13 Nm (1.3 m.kg, 9.4 ft.lb) with a torque wrench.
Engine tightening torques
Cylinder head tightening sequence:
Generator cover tightening sequence:
Clutch cover tightening sequence:
Crankcase tightening sequence:
A. Left crankcase
B. Right crankcase ...
Lubrication points and lubricant types
Engine
Chassis
...
Other materials:
Adjusting the valve clearance
The following procedure applies to all of the
valves.
NOTE:
Valve clearance adjustment should be made
on a cold engine, at room temperature.
When the valve clearance is to be measured or
adjusted, the piston must be at top dead center
(TDC) on the compression stroke.
1. Remove:
...
Checking the engine oil level
1. Stand the vehicle on a level surface.
NOTE:
Place the vehicle on a suitable stand.
Make sure the vehicle is upright.
2. Start the engine, warm it up for several minutes,
and then turn it off.
3. Check:
Engine oil level
The engine oil level should be between the
minimum level ...
Checking the tires
The following procedure applies to both of the
tires.
1. Check:
Tire pressure
Out of specification Regulate.
WARNING
The tire pressure should only be checked
and regulated when the tire temperature
equals the ambient air temperature.
The tire pressure must be adjuste ...