Yamaha YZF-R125 Service Manual: Chassis

Adjusting the headlight beams
The following procedure applies to both of the headlights. 1. Adjust: Headlight beam (vertically) a. Turn the adjusting screw "1" in direction "a" or "b". A. Left headlight B. Right he ...

General chassis
Installing the air filter case 1. Install: Air filter case joint clamp NOTE: Align the projection "a" on the air filter case with the slot "b" in the air filter case joint cl ...

Other materials:

Starting circuit cut-off system operation
If the engine stop switch is set to " " and the main switch is set to "ON" (both switches are closed), the starter motor can only operate if at least one of the following conditions is met: The transmission is in neutral (the neutral switch is closed). The clutch lever is pulled to the ...

Installing the front wheel (disc)
1. Install: Front brake disc NOTE: Be sure to install the front brake disc with the arrow mark "a" on the disc facing out. Tighten the brake disc bolts in stages and in a crisscross pattern. 2. Check: Front brake disc Refer to "CHECKING THE FRONT BRAKE DISC" on page 4 ...

Lubricating the drive chain
The drive chain consists of many interacting parts. If the drive chain is not maintained properly, it will wear out quickly. Therefore, the drive chain should be serviced, especially when the vehicle is used in dusty areas. This vehicle has a drive chain with small rubber O-rings between eac ...

2026 Copyright www.yam-r125.net |