1. Remove:
2. Start the engine, warm it up for several minutes, and then turn it off.
3. Place a container under the engine oil drain bolt.
4. Install:
5. Remove:
6. Drain:
7. If the oil filter element is also to be replaced, perform the following procedure.
a. Remove the oil filter element cover "1" and oil filter element "2".
b. Install the new O-ring "3".
c. Install the new oil filter element and the oil filter element cover.
8. Check:
9. Install:
10.Fill:
11.Install:
12.Start the engine, warm it up for several minutes, and then turn it off.
13.Check:
14.Check:
15.Check:
a. Slightly loosen the oil check bolt "1".
b. Start the engine and keep it idling until engine oil starts to seep from the oil check bolt. If no engine oil comes out after one minute, turn the engine off so that it will not seize.
c. Check the engine oil passages, the oil filter element and the oil pump for damage or leakage.
Refer to "OIL PUMP" on page 5-47.
d. Start the engine after solving the problem(s) and check the engine oil pressure again.
e. Tighten the oil check bolt to specification.
16.Install:
Installing the swingarm
1. Lubricate:
Bearings
Spacers
Dust covers
Pivot shaft
2. Install:
Bearings "1"
2. Swingarm
A. Left side
B. Right side
3. Install:
Swingarm adjusting collar "1"
Swingarm "2"
Pivot shaft
Pivot shaft nut "3"
a. Install, and then fully turn in the swingarm adju ...
Installing the cylinder head
1. Install:
Cylinder head
NOTE:
Pass the timing chain through the timing chain
cavity.
2. Tighten:
Cylinder head bolts "1"
Cylinder head bolts "2"
NOTE:
Lubricate the cylinder head bolts and washers
with engine oil.
Tighten the cylinder head bolts in the proper
tighten ...
Checking the coolant level
1. Stand the vehicle on a level surface.
NOTE:
Place the vehicle on a suitable stand.
Make sure the vehicle is upright.
2. Check:
Coolant level
The coolant level should be between the
maximum level mark "a" and minimum level
mark "b".
Below the minimum level mark → Add t ...