Removing the drive chain
1. Stand the vehicle on a level surface.
WARNING Securely support the vehicle so that there is no danger of it falling over. |
NOTE:
Place the vehicle on a suitable stand so that the rear wheel is elevated.
Checking the drive sprocket
1. Check:
Drive sprocket
More than 1/4 tooth "a" wear
Replace the
drive chain sprockets as a set.
Bent teeth Replace the drive
chain sprockets
as a set.
b. Correct
1. Drive chain roller
2. Drive chain sprocket
Checking the rear wheel sprocket
Refer to "CHECKING AND R ...
Assembling the front wheel
1. Install:
Wheel bearings
Oil seal
a. Install the new wheel bearings and oil seal in
the reverse order of disassembly.
CAUTION:Do not contact the wheel bearing inner
race
"1" or balls "2". Contact should be made
only with the outer race "3".
NOTE:
Use a socket " ...
Checking the ignition spark gap
1. Check:
Ignition spark gap
Out of specification Perform the
ignition
system troubleshooting, starting with step 5.
Refer to "TROUBLESHOOTING" on page
8-3.
NOTE:
If the ignition spark gap is within specification,
the ignition system circuit is operating normally.
a. Disconnect the spa ...