Checking the condition of the bulb sockets
The following procedure applies to all of the bulb
sockets.
1. Check:
Bulb socket (for continuity)
(with the pocket tester)
No continuity Replace.
NOTE:
Check each bulb socket for continuity in the
same manner as described in the bulb section,
however, note the following.
a. Install a ...
Checking the drive sprocket
1. Check:
Drive sprocket
More than 1/4 tooth "a" wear
Replace the
drive chain sprockets as a set.
Bent teeth Replace the drive
chain sprockets
as a set.
b. Correct
1. Drive chain roller
2. Drive chain sprocket
Checking the rear wheel sprocket
Refer to "CHECKING AND R ...
Removing the rear brake master cylinder
NOTE:
Before removing the rear brake master cylinder,
drain the brake fluid from the entire brake system.
1. Disconnect:
Rear brake light switch coupler
2. Loosen:
Rear brake light switch "1"
3. Remove:
Rear brake master cylinder bolts
Rear brake master cylinder
4. Remove:
...