WARNING Bleed the hydraulic brake system whenever:
|
NOTE:
1. Bleed:
a. Fill the brake fluid reservoir to the proper level with the recommended brake fluid.
b. Install the diaphragm (brake master cylinder reservoir or brake fluid reservoir).
c. Connect a clear plastic hose "1" tightly to the bleed screw "2".
A. Front
B. Rear
d. Place the other end of the hose into a container.
e. Slowly apply the brake several times.
f. Fully pull the brake lever or fully press down the brake pedal and hold it in position.
g. Loosen the bleed screw.
NOTE:
Loosening the bleed screw will release the pressure and cause the brake lever to contact the throttle grip or the brake pedal to fully extend.
h. Tighten the bleed screw and then release the brake lever or brake pedal.
i. Repeat steps (e) to (h) until all of the air bubbles have disappeared from the brake fluid in the plastic hose.
j. Tighten the bleed screw to specification.
k. Fill the brake fluid reservoir to the proper level with the recommended brake fluid.
Refer to "CHECKING THE BRAKE FLUID LEVEL" on page 3-18.
WARNING After bleeding the hydraulic brake system, check the brake operation. |
Checking the valve springs
The following procedure applies to all of the
valve springs.
1. Measure:
Valve spring free length "a"
Out of specification Replace the valve
spring.
2. Measure:
Compressed valve spring force "a"
Out of specification Replace the valve
spring.
b. Installed length
3. ...
Chassis tightening torques
NOTE:
First, tighten the lower ring nut to approximately 48 Nm (4.8 m.kg,
35 ft.lb) with a torque wrench, then
loosen the lower ring nut completely.
Retighten the lower ring nut to 13 Nm (1.3 m.kg, 9.4 ft.lb) with a
torque wrench.
...
Disassembling the rear brake caliper
1. Remove:
Brake caliper piston "1"
Brake caliper piston dust seal "2"
Brake caliper piston seal "3"
a. Blow compressed air into the brake hose joint
opening "a" to force out the piston from the
brake caliper.
WARNING
Cover the brake caliper piston with a rag.
Be careful no ...