Install bearings "1" and oil seals "2" so that the manufacturer's marks or numbers are visible.
When installing oil seals "1", lubricate the oil seal lips with a light coat of lithium-soap-based grease. Oil bearings liberally when installing, if appropriate.
CAUTION: Do not spin the bearing with compressed air because this will damage the bearing surfaces. |
Checking the rear brake disc
1. Remove:
Rear wheel
Refer to "REAR WHEEL" on page 4-12.
2. Check:
Brake disc
Damage/galling → Replace.
3. Measure:
Brake disc deflection
Out of specification → Correct the brake
disc
deflection or replace the brake disc.
Refer to "CHECKING THE FRONT BRAKE
DIS ...
Main switch/steering lock
Main switch/steering lock
The main switch/steering lock controls
the ignition and lighting systems, and is
used to lock the steering. The various
positions are described below.
ON
All electrical circuits are supplied with
power, the meter lighting, taillight, license
plate light and ...
Air induction system
1. Air induction system hose (air filter case to
reed valve assembly)
2. Air induction system reed valve assembly
3. Air induction system hose (reed valve
assembly to exhaust pipe)
Checking the air induction system
Air injection
The air induction system burns unburned exhaust
gases b ...