Yamaha YZF-R125 Service Manual: Assembling the water pump

Yamaha YZF-R125 Service Manual / Cooling system / Water pump / Assembling the water pump

1. Install:

Water pump seal "1"
(into the water pump housing "2")

CAUTION:

Never lubricate the water pump seal surface with oil or grease.

NOTE:

Install the water pump seal with the special tools.
Install the water pump seal with the special tools to the specified depth as shown in the illustration.

Assembling the water pump

A. Push down

3. Mechanical seal installer

4. Middle driven shaft bearing driver

Assembling the water pump

a. 0-0.5 mm (0-0.02 in)

2. Lubricate:

Water pump seal lip

3. Install:

Water pump housing gasket "1"

Water pump housing plate "2"
Impeller shaft
Impeller shaft retainer "3"

NOTE:

Before installing the impeller shaft retainer, lubricate the slit on the impeller shaft end with a thin coat of lithium-soap-based grease.
Install the water pump housing gasket, water pump housing plate, and impeller shaft retainer as shown in the illustration.
After installation, check that the impeller shaft rotates smoothly.

Assembling the water pump

Checking the water pump

1. Check: Water pump housing cover Water pump housing Cracks/damage Replace. Impeller shaft Cracks/damage/wear Replace. Bearing Rough movement Replace. Radiator outlet hose Crac ...

Installing the water pump

1. Install: Water pump assembly "1" O-rings "2" NOTE: Align the projection "a" on the impeller shaft with the slit "b" on the camshaft sprocket bolt. Lubricate the O-rings with a thi ...

Other materials:

Installing the rear brake master cylinder
1. Install: Copper washers "1" Brake hose "2" Rear brake light switch "3" WARNINGProper brake hose routing is essential to insure safe vehicle operation. Refer to "CABLE ROUTING" on page 2-33. CAUTION:When installing the brake hose onto the brake master ...

VInstalling the handlebars
1. Stand the vehicle on a level surface. WARNINGSecurely support the vehicle so that there is no danger of it falling over. 2. Install: Front brake master cylinder "1" Front brake master cylinder holder "2" Front brake light switch NOTE: Install the brake master cyl ...

Removing the starter clutch
1. Remove: Starter clutch bolts "1" NOTE: While holding the generator rotor "2" with the sheave holder "3", remove the starter clutch bolts. Do not allow the sheave holder to touch the projection on the generator rotor. ...