1. Thoroughly clean all the gasket mating surfaces and crankcase mating surfaces.
2. Apply:
NOTE:
Do not allow any sealant to come into contact with the oil gallery.
3. Install:
NOTE:
Turn the shift drum segment "1" to the position shown in the illustration. In this position, the shift drum segment teeth will not contact the crankcase during crankcase installation.
4. Install:
NOTE:
Tighten each bolt 1/4 of a turn at a time, in stages and in the proper sequence as shown.
A. Left crankcase
B. Right crankcase
General chassis
Installing the air filter case
1. Install:
Air filter case joint clamp
NOTE:
Align the projection "a" on the air filter case with
the slot "b" in the air filter case joint clamp.
...
Adjusting the rear disc brake
1. Check:
Brake pedal position
(distance "a" from the center of the rider footrest
to the center of the brake pedal)
Out of specification Adjust.
2. Adjust:
Brake pedal position
a. Loosen the locknut "1".
b. Remove the cotter pin "2", washer "3", and
pin "4".
c. Turn t ...
Starting the engine
In order for the ignition circuit cut-off
system to enable starting, one of the
following conditions must be met:
The transmission is in the neutral
position.
The transmission is in gear with
the clutch lever pulled and the sidestand
up.
1. Turn the key to "ON" and make
sure ...