Yamaha YZF-R125 Owners Manual: Adjusting the throttle cable free play

Yamaha YZF-R125 Owners Manual / Periodic maintenance and adjustment / Adjusting the throttle cable free play


  1. Throttle cable free play

The throttle cable free play should measure 3.0-5.0 mm (0.12-0.20 in) at the throttle grip. Periodically check the throttle cable free play and, if necessary, adjust it as follows.

TIP
The engine idling speed must be correctly adjusted before checking and adjusting the throttle cable free play.

  1. Loosen the locknut.
  2. To increase the throttle cable free play, turn the adjusting nut in direction (a). To decrease the throttle cable free play, turn the adjusting nut in direction (b).


  1. Locknut

  2. Adjusting nut

  1. Tighten the locknut.
    Adjusting the engine idling speed
    The engine idling speed must be checked and, if necessary, adjusted as follows at the intervals specified in the periodic maintenance and lubrication chart. The engine should be warm before ...

    Valve clearance
    The valve clearance changes with use, resulting in improper air-fuel mixture and/or engine noise. To prevent this from occurring, the valve clearance must be adjusted by a Yamaha dealer at t ...

    Other materials:

    For your safety - pre-operation checks
    Inspect your vehicle each time you use it to make sure the vehicle is in safe operating condition. Always follow the inspection and maintenance procedures and schedules described in the Owner's Manual. WARNING Failure to inspect or maintain the vehicle properly increases the possibility of ...

    Installing the primary drive gear and balancer gears
    1. Install: Balancer driven gear "1" Lock washer Balancer drive gear "2" Primary drive gear Washer "3" Balancer driven gear nut Primary drive gear nut NOTE: Align the punch mark "a" in the balancer drive gear "2" with the punch mark "b" in the balancer driven gear "1". ...

    Checking the relays
    Check each switch for continuity with the pocket tester. If the continuity reading is incorrect, replace the relay. 1. Disconnect the relay from the wire harness. 2. Connect the pocket tester ( × 1) and battery (12 V) to the relay terminal as shown. Check the relay operation. Out ...

    2024 Copyright www.yam-r125.net |