NOTE:
Be sure to set the CO density level to standard, and then adjust the exhaust gas volume.
1. Remove:
2. Set the main switch to "OFF".
3. Disconnect:
4. Connect:
5. While pressing the "MODE" button "1", turn the main switch to "ON".
NOTE:
6. Press the "UP" button "4" to select the CO adjustment mode "CO" or the diagnostic mode "DIAG".
7. After selecting "CO", press the "MODE" button.
8. Check that "C1" appears on the LCD of the FI diagnostic tool, and then press the "MODE" button.
9. Start the engine.
CAUTION: Perform the adjustment after the battery has been sufficiently charged. |
10.Change the CO adjustment volume by pressing the "UP" and "DOWN" buttons.
NOTE:
The CO adjustment volume and engine idling speed appears on the LCD of the FI diagnostic tool.
11.Release the "DOWN" and "UP" buttons to execute the selection.
12.Set the main switch to "OFF" to cancel the mode.
13.Disconnect:
14.Connect:
15.Install:
Removing the piston
1. Remove:
Piston pin clips "1"
Piston pin "2"
Piston "3"
CAUTION:Do not use a hammer to drive the piston
pin
out.
NOTE:
Before removing the piston pin clip, cover the
crankcase opening with a clean rag to prevent
the piston pin clip from falling in ...
Lubricating the drive chain
The drive chain consists of many interacting
parts. If the drive chain is not maintained properly,
it will wear out quickly. Therefore, the drive
chain should be serviced, especially when the
vehicle is used in dusty areas.
This vehicle has a drive chain with small rubber
O-rings between eac ...
Multi-function display
1. Multi-function display
2. "RESET/SELECT" button
The multi-function display is equipped with the
following:
a speedometer (which shows the riding speed)
an odometer (which shows the total distance
traveled)
two tripmeters (which show the distance traveled
since they were last ...