NOTE:
Prior to adjusting the engine idling speed, the air filter element should be clean, and the engine should have adequate compression.
1. Start the engine and let it warm up for several minutes.
2. Remove:
3. Lift the fuel tank. (Do not disconnect the fuel hose, fuel drain hose, and couplers.) Refer to "FUEL TANK" on page 7-1.
4. Install:
5. Check:
Engine idling speed Out of specification → Adjust.
6. Remove:
7. Adjust:
a. Turn the pilot screw "1" in direction "a" or "b" until the specified engine idling speed is obtained.
8. Remove:
9. Install:
10.Adjust:
Faulty clutch
Clutch slips
1. Clutch
Improperly assembled clutch
Improperly adjusted clutch cable
Loose or fatigued clutch spring
Worn friction plate
Worn clutch plate
2. Engine oil
Incorrect oil level
Incorrect oil viscosity (low)
Deteriorated oil
Clutch drags
1. Clutch
Unevenly t ...
Replacing the rear brake pads
NOTE:
When replacing the brake pads, it is not necessary
to disconnect the brake hose or disassemble
the brake caliper.
1. Remove:
Brake pads
Brake pad spring
NOTE:
To remove the inner brake pad "1", push down
on the brake caliper bracket so that there is
space to remove the brake pa ...
Measuring the compression pressure
NOTE:
Insufficient compression pressure will result in a
loss of performance.
1. Measure:
Valve clearance
Out of specification →Adjust.
Refer to "ADJUSTING THE VALVE CLEARANCE"
on page 3-3.
2. Start the engine, warm it up for several minutes,
and then turn it off.
3. Remove:
...