Yamaha YZF-R125 Owners Manual: Adjusting the clutch lever free play
Adjusting the clutch lever free play
- Clutch lever free play adjusting bolt
- Clutch lever free play
The clutch lever free play should measure 10.0-15.0 mm (0.39-0.59 in) as shown. Periodically check the clutch lever free play and, if necessary, adjust it as follows.
- Slide the rubber cover back at the clutch lever.
- Loosen the locknut.
- To increase the clutch lever free play, turn the adjusting bolt in direction (a). To decrease the clutch lever free play, turn the adjusting bolt in direction (b).
TIP
If the specified clutch lever free play
could be obtained as described above,
skip steps 4-7.
- Fully turn the adjusting bolt at the clutch lever in direction (a) to loosen the clutch cable.
- Loosen the locknut at the crankcase.
-
Locknut
-
Clutch lever free play adjusting nut (crankcase)
- To increase the clutch lever free play, turn the adjusting nut in direction (a). To decrease the clutch lever free play, turn the adjusting nut in direction (b).
- Tighten the locknut at the crankcase.
- Tighten the locknut at the clutch lever and then slide the rubber cover to its original position.
Cast wheels
To maximize the performance, durability,
and safe operation of your vehicle,
note the following points regarding the
specified wheels.
The wheel rims should be checked
for cracks, bends o ...
Checking the front brake lever free play
Checking the front brake lever free play
Brake lever free play
The brake lever free play should measure
2.0-5.0 mm (0.08-0.20 in) as
shown. Periodically check the brake lever
free pla ...
Other materials:
Installing the camshaft and rocker arms
1. Lubricate:
Rocker arms
Rocker arm shafts
2. Lubricate:
Camshaft
3. Install:
Camshaft "1"
NOTE:
Make sure that the camshaft projections "a" and
hole "b" are positioned as shown in the illustration.
4. Install:
Rocker arms
Rocker arm shafts "1"
NOTE:
Make ...
Replacing the rear brake pads
NOTE:
When replacing the brake pads, it is not necessary
to disconnect the brake hose or disassemble
the brake caliper.
1. Remove:
Brake pads
Brake pad spring
NOTE:
To remove the inner brake pad "1", push down
on the brake caliper bracket so that there is
space to remove the brake pa ...
Identification
Vehicle identification number
The vehicle identification number "1" is stamped
into the right side of the steering head pipe.
Model label
The model label "1" is affixed to the frame. This
information will be needed to order spare parts.
...