1. Check:
Clutch cable free play "a"
Out of specification Adjust.
2. Adjust:
a. Pull back the rubber cover "1" b. Loosen the locknut "2".
c. Turn the adjusting bolt "3" in direction "a" or "b" until the specified clutch cable free play is obtained.
d. Tighten the locknut.
e. Place the rubber cover in its original position.
NOTE:
If the specified clutch cable free play cannot be obtained on the handlebar end of the cable, use the adjusting nut on the engine end.
3. Remove:
a. Loosen the locknut "1".
b. Turn the adjusting nut "2" in direction "a" or "b" until the specified clutch cable free play is obtained.
c. Tighten the locknut.
4. Install:
Replacing a turn signal light bulb
Remove the turn signal light lens
by removing the screw.
Screw
Remove the burnt-out bulb by
pushing it in and turning it counterclockwise.
Insert a new bulb into the socket,
push it in, and then turn it clockwise
until it stops.
Install the lens by installing ...
Installing the thermostat
1. Install:
Thermostat
NOTE:
Install the thermostat with its breather hole "a"
facing up.
2. Install:
Copper washer
Coolant temperature sensor
CAUTION:Use extreme care when handling the
coolant
temperature sensor. Replace any part that
was dropped or subjected to ...
Checking the primary driven gear
1. Check:
Primary driven gear "1"
Damage/wear Replace the
primary drive
gear and clutch housing as a set.
Excessive noise during operation
Replace
the primary drive gear and clutch housing as
a set.
...