Yamaha YZF-R125 Owners Manual: Changing the brake fluid

Have a Yamaha dealer change the brake fluid at the intervals specified in the periodic maintenance and lubrication chart. In addition, have the brake hose replaced every four years or whenever it is damaged or leaking.

    Checking the brake fluid level
    Front brake Front brake Minimum level mark Rear brake Rear brake Minimum level mark Insufficient brake fluid may allow air to enter the brake system, possibly causing it to ...

    Drive chain slack
    The drive chain slack should be checked before each ride and adjusted if necessary. To check the drive chain slack Place the motorcycle on the sidestand. TIP When checking and adjusting t ...

    Other materials:

    Removing and installing the cowlings and panel
    Removing and installing the cowlings and panel Cowling A Cowling B Cowling C Cowling D Panel A The cowlings and panel shown need to be removed to perform some of the maintenance jobs described in this chapter. Refer to this section each time a cowling or panel needs to be ...

    Installing the rear wheel (disc)
    1. Install: Rear brake disc NOTE: Tighten the brake disc bolts in stages and in a crisscross pattern. 2. Check: Rear brake disc Refer to "CHECKING THE REAR BRAKE DISC" on page 4-33. 3. Lubricate: Rear wheel axle Contact surface of rear wheel hub and rear wheel Whee ...

    Adjusting the valve clearance
    The following procedure applies to all of the valves. NOTE: Valve clearance adjustment should be made on a cold engine, at room temperature. When the valve clearance is to be measured or adjusted, the piston must be at top dead center (TDC) on the compression stroke. 1. Remove: ...

    2019 Copyright www.yam-r125.net |